What Is MARSHINE Adjustable Cable Longitudinal Slitter?
The MARSHINE Adjustable Cutting Depth Round Cable Longitudinal Slitter is a professional grade equipment for slitting round cables including electrical wires with high speed and stable quality. It features adjustable cutting depth for a wide range of wire sizes and types and is suitable for cable manufacturer, recycler, service provider.
So How To Use MARSHINE Adjustable Cable Longitudinal Slitter Properly?
Preparation of Slitter for Work
Preparation
Before slitting cables,you need to prepare your MARSHINE Adjustable Cutting Depth Round Cable Longitudinal Slitter:
Check the tool Look over all the slitter parts: blades, rollers, covers, adjustment knobs, spool, does everything look complete and clean? Is there any part damaged? malfunctioned?
Verify the depth of cut adjustment to make sure the depth of cut setting on your adjustable slitter is appropriately for the job so as not to cut too deep into the cable or too close to the conductor.
Rest the tool on a stable workbench or secure it to the bench, as if you intended to let your dog use the tool without supervision.
Safety gloves, goggles and apron should be used to protect from sharp blades, flying debris.
Adjusting the Depth of Cut
This powerful adjustable longitudinal slitter features deep adjustable cutting depth custom made blade compatible with many manufacturers auto stripping machine. To adjust the cutting depth:
Find the depth adjustment wheel (This is usually found near the blade on the slitter).
Rotate the knob: Turn to change the cutting depth. Set the depth based on the thickness of the insulation on the conductor of the wire you'll be slitting. Test the setting: Before doing real work, run a short piece of wire into the slitter to confirm the cutting depth is right and that the blade is not cutting into the conductor.
Readjust as necessary: If the sample cut is either too small or too large, adjust the depth finely until it is.
Using the Slitter
After the tool is properly set up and sleeves are inserted, you can start slitting the cables:
Put the cable in the slitter: Place the round cable in the tool and make sure that the cable is centered between the rollers and beneath the cutting blade.
Begin the slitting: With some models this involves turning a hand crank, pulling a lever, or starting a motor to commence the cutting.
Feed the cable consistently: While you are running the tool, push the cable through it evenly in the same pace so the cable will be slit evenly along the length of the wire.
Keep an eye on the cut: Monitor tightly as you split the cable to ensure you're splitting the cable evenly and depth of cut stay consistent. Reposition the cable if necessary.
